OPERATION
www.maxcessintl.com
DLCA NET-S1
MI 850A374 1 A
Page 23 of 67
4.7
Programming mode
Enter the programming menu
Press and hold [+] and [-] for two seconds.
Exit the programming menu
Press and hold [+] and [-] for two seconds from a menu item
other than the load cell calibrations menu items.
Also: while showing parameter P.17, you may press [ENTER] to
exit the menu and return to displaying the tension.
Parameter number
While in the programming mode, the display shows P.xx, where
xx is the parameter number. There are also calibration and
setup menus that have sub-menus. (See the menu flowchart;
Appendix A.)
Press [+] or [-] to increment or decrement the parameter
number to step through the main menu loop. Press [Enter] to
enter the data entry mode for a parameter or to enter a sub-
menu.
Use [+] or [-] to change the value of a parameter. The digit
being edited will flash. Use [
] to change which digit position is
being edited. Press [Enter] and release to cancel the data change
and return to the menu. Press [Enter] and hold for two seconds
(until the display starts flashing) to save the changed parameter.
If the data has been changed and the data has not been saved,
after five seconds of no button activity the display will flash
indicating the data needs to be saved.
The sub-menus are used to step the operator through the
calibration sequence or to access a group of parameters. Press
[Enter] when a menu other than P.xx menu is showing to get into
the sub-menu. The CALx menu automatically steps through
each parameter and calibration function. The other sub-menus
do not auto-step. When a sub-menu item is showing, use [+] or
[-] to get to the other sub-menu parameters.
When in the programming mode and no buttons have been
pressed for two minutes, the DLCA NET-S1 exits the
programming mode and returns to displaying tension. This
menu time-out is not active once any of the calibration loops
have been entered.
