Page
5
of
13
SPECIFICATIONS*
Wingspan ............................................................................................................ 50 inches
Wing Area .................................................................................................... 490 sq. inches
Overall Length ..................................................................................................... 41 inches
Flying weight ....................................................................................................... 5 pounds
Wing Loading ................................................................................................ 23.5 oz/sq. ft.
Power System (Not included) .............. Maxford U35425 and U60 amp ESC or equivalent
Propeller (Not included) ................................... 11x7e (or as-recommended for your motor)
Battery (Not included) .................................................................... 4s, 3300-4000mAh LiPo
Radio system (Not included) ................................ Minimum of 5 channels, 4 micro servos
*(All dimensions and weights are approximate.)
PARTS LIST
Items included with this Hughes H-1
Precovered fuselage, wing panels, and tail surfaces.
Prepainted fiberglass cowl with dummy engine.
Prepainted plastic tail fairings.
Precut hinge openings and all needed CA hinges.
Retractable landing gear assembled and installed.
Composite wing joiner tube, installed pushrods, and all related hardware (except
those items normally supplied with servos and the electric motor).
Items you must supply to complete this Hughes H-1
5- and 30-minute epoxy glue, thin and thick Cyanoacrylate (CA) adhesives,
and a few common hand tools (such as long-nosed and diagonal or side-cutter
pliers, Phillips screwdriver, etc.).
A 600 to 750 watt brushless outrunner electric motor.
An Electronic Speed Control and propeller to suit your motor.
Four micro size servos, two 12-inch extensions, two short Y-connectors and a
5 or more channel radio control system.
A 4s LiPo battery.
ASSEMBLY INSTRUCTIONS
BEFORE YOU START:
Open the box and look over the parts. Check everything against the parts list and
make sure everything is there and undamaged. If anything is missing or broken,
contact Maxford USA at the address given on the last page of this manual within 10
days of receipt of the kit
If necessary, use a covering iron to go over the covering material on all of the parts
to eliminate any loose edges or air bubbles, then re-shrink the covering over all the
open areas using the iron or a heat gun.
Note: References to
left
and
right
are as if you were standing behind the airplane.
