70
I
Beryl
I
Maxi-Cosi
EN
A - Adjustable headrest
B - Newborn headrest
C - Inlay
D - 5-point Harness
E - Shoulder pads
F - Harness buckle
G - Harness adjuster button
H - Harness adjuster strap
I - Recline handle
J - Car seat release button
K - Indicator car seat locked in position
L - Support leg indicator
M - Support leg
N - Headrest adjustment handle
O - GCell
P - Instruction manual storage
Q - ISOFIX connectors release button
R - ISOFIX connectors
S - Support leg adjuster button
T - Support leg height adjustment rack
U - Vehicle belt fastener
V - Gr2 headrest unlock button
SAFETY
• The Beryl is intended for car use only.
• The Beryl is developed for an intensive use of
approximately 12 years.
• Do not use any load bearing contact points
other than those described in the instructions
and marked in the child restraint.
The Beryl car seat in the car:
• Before buying this product make sure the
car seat is compatible with the vehicle it is to
be used in.
• It is recommended to adjust to full recline
position before ISOFIX system installation.
After correct installation of the ISOFIX
connector and support leg, adjust to the
proper recline position for your child.
• The Beryl support leg must always be
unfolded completely, locked and placed in the
most forward position.
WARNING:
• The base is intended for use with the Beryl
car seat only. Do NOT fit any other car seat on
Beryl base.
• When installing the car seat, spaces between
the base of the car seat and the vehicle seat
are possible depending on the position of the
anchorage points within the vehicle.
• If you use the Beryl on the front seat, it is
recommended to deactivate the airbag of the
seat in question and move the passenger seat
back to a maximum (Please consult your car
manual).
ATTENTION:
In ISOFIX use the fitting clips for lower
anchorage to the vehicle are not sufficient.
It is essential to fix the “Support Leg” .
190000267_MC_014802801_Beryl_scenariomanual_insert_116x116mm_v9.indd 70
25/04/2019 09:36
