39
40
Recheck
Recline Angle
Make sure the
ball is fully in
the color zone
that matches the
weight of your
child.
Repeat steps 1 through 6 if not in
correct zone.
NOTE:
Check the angle indicator while
parked on level ground.
7.
To Remove
LATCH Belt
From Vehicle
Anchor
Remove child
restraint from
base. Press the red release button on
each connector. Pull LATCH connector
away from the LATCH anchor bar.
8.
E-4
Installing Base with
Vehicle Belts
Do not use the LATCH system
along with the vehicle lap or
lap/shoulder belt. Store LATCH
belts when using the vehicle
belts.
Check the vehicle belt before
each use. Use only if the belt
is tightened properly and
securely.
Failure to follow these
warnings can result in serious
injury or death.
E. Installing Base with Vehicle Belts
Place ball in the zone of y
our infant’s weight.
11-30 lbs
(4.9-14 kg)
4-11 lbs
(1.8-4.9 kg)
Place ball in the zone of your infant’
s weight.
11-30 lbs
(4.9-13.6 kg)
4-11 lbs
(1.8-4.9 kg)
continued on next page
Store LATCH
Belts
You
MUST
store the LATCH
system when
using the vehicle
seat belts.
1.
Place Base in
Vehicle Rear-
Facing
Center the base
in the chosen
seating position.
2.
Place ball in the z
one of your infant’s weight
.
11-30 lbs
(4.9-14 kg)
4-11 lbs
(1.8-4.9 kg)
Check
Recline Angle
Check the
angle indicator
on the base.
The ball should
be fully in the
color zone that
matches the weight of your child.
Adjust base if needed. (see section
C-2).
NOTE:
Check the angle indicator
while parked on level ground.
Place ball in the zone of your infant’
s weight.
11-30 lbs
(4.9-13.6 kg)
4-11 lbs
(1.8-4.9 kg)
3.
Do not use level to ground lines
on child restraint when using
the base.