You may need
to place a large
rolled towel(s)
or foam pool
noodle(s) under
the front of the
child restraint to achieve correct recline
angle.
Check often to be sure padding is still in
place and the belt is tight.
NOTE:
The carrying handle can be in any
position when installed in the vehicle.
47
48
Position
Locking Clip
Position locking
clip about 1 in.
(2.5 cm) from
vehicle belt’s latch plate. Rebuckle
vehicle belt.
6.
Locate Locking
Clip Location
Grasp both vehicle
belts together just
behind the latch plate and unbuckle.
NOTE:
If the latch plate ends up just
at the belt path opening so you cannot
grasp the vehicle belt at the latch plate,
grasp the vehicle belts on the opposite
side of the child restraint, as close to
the latch plate as possible. Install the
locking clip on the latch plate end, as
close as possible.
4.
Attach Locking
Clip
Thread both
portions of the
vehicle belt onto
the locking clip, as
close to the latch
plate as possible.
5.
E. Using the Locking Clip
Thread Vehicle
Belt
Thread vehicle lap
belt only through
the belt path (as
shown). Buckle
the vehicle belt.
2.
Tighten Vehicle
Belt
Lay your forearm
across child
restraint at the
belt path while pulling up on belt to
tighten.
3.
.
Check
Vehicle Belt
Tightness
Grasp
the child
restraint at the belt path
with
one hand. Push and pull the child
restraint from side to side, forward
and back. The child restraint should
not move more than 1 inch.
NOTE:
If child restraint moves more
than 1 inch, try reinstalling the
child restraint or try another seating
location.
7.
11-30 lbs (4.9-13.6 kg) Lev
el to Ground Line
Recline the infant seat so th
at the red line
that matches the weight of y
our child
is level to the ground
(when used without the ba
se)
4-11 lbs (1.8-4.9 kg)
Level to Ground Line
4360-2115
continued on next page
