To Change
Buckle Position
Remove child.
From under
the seat, insert
buckle’s metal retainer up through the
child restraint and pad.
For smaller infants skip to step
“d”.
15
16
C-5
Preparing Child Restraint to Fit Your Child
Make these adjustments with your
child in the child restraint before
you install in the vehicle.
To Remove
Child Restraint
from Base
From the back of
the child restraint,
pull out on base
release handle
and lift child restraint out of base.
Loosen Harness
Push down on
the harness
release button
while pulling out
on both harness
straps.
2.
1.
Release Chest
Clip
Press on chest
clip release
button and pull
apart.
3.
C. Basic Use
Unbuckle
Harness
Press red button.
Pull buckle
tongues out.
4.
Place Child in
Child Restraint
Place the child’s
bottom and back
flat against the
child restraint.
This will increase comfort and allow the
harness straps to be properly tightened.
Check Buckle
Position
Determine which
of the available
buckle positions
will be most
comfortable and
provide a snug fit
for your child.
6.
a.
Choose new
location and
push the metal
retainer through
pad and child
restraint. Make sure the buckle is
facing out.
b.
Pull on the
buckle to check
to make sure
buckle’s metal
retainer is
completely inserted through the pad
and child restraint.
c.
continued on next page
Failure to reinstall the harness
system correctly can result in
serious injury or death.
5.
