58
message will appear on the screen. P
ress “
OK
” to exit.
Parking Brake: Workshop Mode
This service is used to activate and deactivate the so-called installation
position for the Automatic Hold brake. In this mode the parking brake is
move
into the opened position and temporarily deactivated (personal protection).
The installation position must be activated for the following repairs:
Replacement of brake pads.
Replacement of a brake caliper.
Replacement of an actuator.
Select
Parking Brake: Workshop Mode
and follow the on-screen
instructions to perform a series of operations to start the brake pad after
replacement.
When the operation is successfully completed, a “Completed successfully”
message will appear on the screen. Press “
OK
” to exit.
BMS
The BMS (Battery Management System) allows the scan tool to evaluate the
battery charge state, monitor the close-circuit current, register the battery
replacement, activate the rest state of the vehicle, and charge the battery via
the diagnostic socket.
NOTE
1. This function is not supported by all vehicles. The screens shown in this
section are examples.
2. The sub functions and actual test screens of the BMS may vary for
different test vehicles, please follow the on-screen instructions to make
correct option selection.
The vehicle may use either a sealed lead-acid battery or an AGM (Absorbed
Glass Mat) battery. Lead acid battery contains liquid sulphuric acid and can
spill when overturned. AGM battery (known as VRLA battery, valve regulated
lead acid) also contains sulphuric acid, but the acid is contained in glass mats
between terminal plates.
It is recommended that a replacement aftermarket battery has the same
specifications, such as capacity and type, of the battery used in the vehicle.