87
The sensor IDs retrieved from sensor activation and TPMS ECU will
automatically appear on the left column of the table on the screen with the
trigger and OBD marks before them.
If the OBD function is not supported by the test vehicle and the sensor ID
saved in the ECU cannot be retrieved, the Programming screen appears as
below.
Figure 6-17
Sample Programming Screen 2
And in this case, the
Copy by OBD
function is not available.
Copy by Active
If the sensors that are mounted on the vehicle can be successfully triggered
and the detailed information of the sensors have already been retrieved by
using
Check
function. You can use
Copy by Active
to program a new
MX-Sensor.
Select one sensor position and place a MX-Sensor near the TPMS antenna
of the tablet (the top right corner), and then tap
Copy by Active
to program
the new MX-Sensor.
Summary of Contents for MX808TS
Page 80: ...73 Figure 5 30 Sample IMMO Note Screen Figure 5 31 Sample Program Key FOB Screen ...
Page 83: ...76 Figure 6 2 Sample Vehicle Manufacturer Selection Figure 6 3 Sample Vehicle Model Selection ...
Page 128: ...121 Programmer Update Coming soon ...
Page 162: ...155 Figure 17 3 Sample Function Viewer Screen 3 ...
