90
Figure 6-21
Sample Copy by OBD Screen
When the programming is complete, the programmed ID will appear to the
right of the FR column.
By using
Copy by OBD
, the sensor ID that is retrieved from TPMS ECU is
programmed to the new MX-Sensor.
In this case, there is no need to perform the
Relearn
function to write the ID
into the ECU.
It is highly recommended to use
Copy by OBD
, if available, to program new
MX-Sensors for the IDs are definitely correct and there is no need for
Relearn.
Copy by Input
The
Copy by Input
allows users to program a new MX-Sensor with the ID
of an original TPMS sensor.
Select one sensor position and place a MX-Sensor near the TPMS antenna
of the tablet (the top right corner), and then tap
Copy by Input
to program
the new MX-Sensor.
Summary of Contents for MX808TS
Page 80: ...73 Figure 5 30 Sample IMMO Note Screen Figure 5 31 Sample Program Key FOB Screen ...
Page 83: ...76 Figure 6 2 Sample Vehicle Manufacturer Selection Figure 6 3 Sample Vehicle Model Selection ...
Page 128: ...121 Programmer Update Coming soon ...
Page 162: ...155 Figure 17 3 Sample Function Viewer Screen 3 ...
