Spangenberg International B.V.
– Nijverheidsweg 19F – 3641 RP Mijdrecht – Holland – T. +31 (0) 297 253 969 – F. +31 (0) 297 256 445
Product Specific Safety Regulations
•
This machine may only be used for its intended purpose: To apply a thin layer of frost or ice on a glass.
•
Please use this appliance in a well-ventilated area to avoid CO2 accumulation
•
This product works with liquid CO2 only. Never connect any other (compressed) gas cylinders.
•
Inform yourself about the use and characteristics of liquid CO2. Contact your CO2 supplier for more details.
•
WARNING! Extremely low temperatures can cause injuries, handle with care.
First Time Use
•
Unpack and inspect your machine immediately after receipt. If there are any latent defects or damage to
the machine then immediately contact your supplier. Save all packaging materials in case the machine
needs to be returned or inspected by the freight carrier.
•
Remove any protective film from all surfaces (if applicable).
•
Read this instruction manual completely before attempting to install and operate this product. When in
doubt, contact your supplier.
•
If your machine is supplied with a factory fitted molded plug then you may plug the unit into a standard
electrical outlet. Make sure that the voltage of the machine and the wall outlet are compatible. If your
machine is not supplied with a factory fitted molded plug then a qualified electrical engineer must be
contracted to wire the unit to the power supply.
•
Before using the appliance for the first time, it is recommended to clean the appliance according to
instructions
(see chapter “
Cleaning and Maintenance
”
).
