Spangenberg International B.V.
– Nijverheidsweg 19F – 3641 RP Mijdrecht – Holland – T. +31 (0) 297 253 969 – F. +31 (0) 297 256 445
•
Do not place the machine on its side, upside-down or tilt the appliance more than 45° from the vertical. Also
while the appliance is being transported.
•
The electrical installation must satisfy the applicable national and local regulations.
First Time Use
•
Unpack and inspect your machine immediately after receipt. If there are any latent defects or damage to
the machine then immediately contact your dealer. Save all packaging materials in case the machine needs
to be returned or for inspection by the freight carrier.
•
Remove any protective film from all surfaces.
•
Read this instruction manual completely before attempting to install and operate this product. All
installations and set ups must be done by authorized service agents, your dealer, or Maxima
representatives.
•
If your machine is supplied with a factory fitted molded plug then you may plug the unit into a standard
electrical outlet. Make sure that the voltage of the machine and the wall outlet are compatible. If your
machine is not supplied with a factory fitted molded plug then a qualified electrical engineer must be
contracted to wire the unit to the power supply.
•
Before using your appliance for the first time it is recommended to clean the appliance according to
instructions mentioned in
chapter “
Cleaning and Maintenance
”
.
Installation
1.
The machine must be positioned on a flat and stable surface.
2.
Choose a surface where the machine is not exposed to direct sunlight, or close to a direct source of heat
such as a cooker, oven or radiator.
3.
When positioning the appliance, maintain a distance of 10cm (4 inches) between the appliance and walls or
other objects for ventilation and ease of use.
4.
Level the appliance using the adjustable feet and position the machine in such a way that the plug is
accessible at all times. The appliance may operate less effectively if not level.
5.
Mount the tap, place the filter tray in position and the waste bins on either side.
6.
Plug the power plug into the main socket.
