Spangenberg International B.V.
– Rendementsweg 24P – 3641 SL Mijdrecht – Holland – T. +31 (0) 297 253 969 – F. +31 (0) 297 256 445
Do not use any extra devices that are not supplied along with the machine.
Avoid overloading.
The electrical installation must satisfy the applicable national and local regulations.
First Time Use
Unpack and inspect your machine immediately after receipt. If there are any latent defects or
damage to the machine then immediately contact the freight carrier as well as your dealer. Save
all packaging materials for inspection by the freight carrier.
Read this instruction manual completely before attempting to install and operate this product. All
installations and set ups must be done by authorized service agents, your dealer, or Maxima
representatives.
The machine must be positioned on a flat surface with sufficient space around the machine to
allow for easy access to the machine, and for cleaning and ventilation.
If your machine is supplied with a factory fitted molded plug then you may plug the unit into a
standard electrical outlet. Make sure that the voltage of the machine and the wall outlet are
compatible. If your machine is not supplied with a factory fitted molded plug then a qualified
electrical technician must be contacted to wire the unit to the power supply.
Before using your machine for the first time it is recommended that the exterior of the machine is
wiped down with a damp cloth, and the bowl, lid and knife are washed using a food safe cleaning
detergent and rinsed with warm water.
Level and position the machine in such a way that the plug is accessible at all times.
Operation
Plug the machine into the main socket.
Before turning on the cutter, fill the bowl with the product to be processed and put it correctly on
the motor base. Make sure that the bowl connects with the safety switch.
Warning!
Never overload the machine. Never fill the machine more than 50% of the bowl
capacity. In case of heavy operation this capacity may even be less. Consult your authorized
reseller in case of doubt.
Suggestion!
We advise you to not put large chunks in the cutter, but smaller pieces.
Make sure that the lid is the perfect position and in contact with the safety switch.
Once the speed has been selected, press the green start button to activate the cutter. The bowl
and lid must be fixed correctly for the cutter to operate. If the bowl and lid are not fixed properly
then the cutter will not function.
To change speeds you can use the switch on the side of the appliance. With this switch you can
change speeds easily.
When cutting light batches it is recommended that the cutter is not used continuously for a time
period of more than 30 minutes and a cooling off period of 15-20 minutes should be allowed
between cycles.
When cutting heavier batches it is recommended that the cutter does not run for more than 15
minutes continuously and a cooling off period of 20-30 minutes should be allowed between
batches.
