9
SprayMate HVLP ST610 TNT
US
1
2
12
9) Turn on the system and spray the
cleaner into a sink or a cloth.
10) Fill container with 2 fl. oz of water, spray
until empty.
11) Repeat the above procedure until the
water emerging from the nozzle is clear.
12) Turn off the system and divide the spray
gun.
13) Unscrew the container and empty it.
Pull out the feed tub with container seal.
CAUTION!
NEVER clean seals, nozzles or
air holes of the spray gun with
metal objects.
14) Unscrew the union nut and remove the
air cap and nozzle (Fig. 11). Clean the
air cap, nozzle seal and nozzle with a
brush and water.
15) Clean the outside of the spray gun and
container with a cloth soaked in water.
16) Assemble the parts again (see
“Assembly”).
1
10
11
Assembly
1) Slide the nozzle seal (Fig. 12, 1) with the
groove (slot) facing forwards into the
nozzle (2).
2) Put the nozzle onto the gun body and find
the correct position by turning it.
3) Put the air cap onto the nozzle and tighten
it using the union nut.
4) Place the container seal (Fig. 13, 1) from
below on the feed tube (2) and slide it over
the collar, while turning the container seal
slightly.
5) Insert the feed tube with container seal
in the gun body.
13
1
2
3
