Maximum 054-7291-6, Instruction Manual

15

®

model no. 054-7291-6  |  contact us 1-888-670-6682

14

•     Hold the tool firmly with both hands. Using the rear handle to control the sander and 

the front handle only to guide it, move it slowly over the workpiece. Allowing the 

sander to remain in one place will result in an uneven surface. 

•     Apply proper pressure on the sander. Excessive pressure may cause stalling, 

overheating of the motor, burning of the workpiece and possible kickback.

STATIONARY USE (FIG. G)

This sander can also be used in stationary operation for certain 

tasks. You can use the two fixing clamps provided to secure the 

sander on a stable surface. 
In stationary operation, always use the “lock-on” function for 

continuous operation.

MAINTENANCE

WARNING!

•   Make sure that the surface is safe and does not wobble.

•  In stationary operation, always work with the greatest of 

attention. There is a risk of injury to hands and fingers by 

slipping on the workpiece.

•  To prevent personal injury, hold workpiece with both hands in 

stationary operation.

OPER

A

TING INS

TRUCTIONS

WARNING!

•  When servicing use only identical replacement parts. Use 

of any other parts may create a hazard or cause product 

damage.

•  Always wear safety goggles or safety glasses with side 

shields during power tool operation or when blowing dust. If 

operation is dusty, also wear a dust mask.

•  Do not at any time let brake fluids, gasoline, petroleum-based 

products, penetrating oils, etc., come in contact with plastic 

parts. Chemicals can damage, weaken or destroy plastic which 

may result in serious personal injury.

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to 

damage from various types of commercial solvents and may be damaged by their use. 

Use clean cloths to remove dirt, dust, oil, grease, etc.

LUBRICATION

All of the bearings in this tool are lubricated with a sufficient amount of high grade 

lubricant for the life of the unit under normal operating conditions. Therefore, no further 

lubrication is required.
NOTE: It is suggested to have the carbon brushes replaced by an authorized service 

centre.