19
18
model no. 058-9345-0 | contact us 1-888-670-6682
Note:
A slot screwdriver may be used to gently lift the O-ring
from the end of the trigger pin.
WARNING!
Potential hazard that could result in serious injury
or loss of life.
•
Mode Conversion
•
•
•
•
•
•
•
Hold the gun properly and be mindful of the kick-back
after each nail shot. Failure to comply will lead to serious
injury or loss of life.
To convert the nailer from one
mode to the other, remove the
current trigger and install the
other trigger.
Removing the Current
Trigger
Remove the O-ring (1) from the
trigger pin (Fig. H).
Slowly remove the trigger pin (1) and
then the trigger. Use your thumb to hold
the trigger spring in place (Fig .H).
Adjusting the Nail Depth
For varying materials, the nail depth can be
adjusted tool-free with the depth adjustment
dial (Fig. K).
Installing the New Trigger
Place the new trigger (1) with your thumb
holding the spring (2) in place (Fig. I).
Align the holes on top of the trigger and the
holes on the casing of the nailer.
Insert the trigger pin (1) through the holes.
Put it back to where it was removed (Fig. J).
Push the O-ring back on to the trigger pin.
Make sure it is tightly secured and sits in the
recess.
Note:
Refer to the graphic imprinted below the trigger and
adjust the firing depth accordingly.
CAUTION!
Potential hazard that may result in moderate injury
or damage to equipment.
•
Do not attempt to modify the trigger components in any
manner and do not attempt to use any other trigger
components other than those intended for this tool.
Failure to comply will lead to moderate injury or
damage to equipment.
Fig. G
1
Fig. H
1
Fig. I
1
2
Fig. J
1
Fig. K
TM
