Maxkon WS-1081PC, Operation Manual

Important Notes: 

On the edge of wind direction sensor, there are four alphabet letter of “N”,”E”,”S”and “W” representing 
for the direction of North, East, South and West. Wind direction sensor has to be adjusted so that the 
directions on the sensor are matching with your real location. Permanent wind direction error will be 
introduced when the wind direction sensor is not positioned correctly during installation. 

Wind speed sensor wire has to be inserted into the phone jacket on wind direction sensor. 

Wind direction sensor wire has to be inserted into the phone jacket located on the thermo-hygro 
sensor with marking of “Wind” on top. 

The rain sensor wire has to be inserted into the phone jacket located on the thermo-hygro sensor with 
marking of “Rain” on top. 

System Start 

Insert two pieces of LR6(AA size) batteries into the transmitter, the LED located in the middle front 
case of transmitter will be turned on for 4 seconds, then it will be off and start to work normally. The 
transmitter will make a data transmission. When there is a data transmission happened, the LED will 
be on for 20ms.   

After inserting the batteries into the Weather Station, all LCD segments will be turned on for a few 
seconds; all possible display segments are turned on for checking.         
   
After this, the weather station will make initial measurement and start to register the transmitter ( the 
radio reception icon will be turned on). Before there is outdoor data received, it is not allowed to touch 
the LCD, otherwise the outdoor sensor learning mode will be terminated right after the touch of LCD. 
When outdoor transmitter has been registered, the Touch Screen Weather Station will automatically 
switch to the normal display mode from which all further settings can be performed by the user.         

NOTE: Wait two minutes before re-insert the batteries of transmitter for proper reset.  

- 5 - 

⑧