Installation: V-Hook & Chain Mounting
© Copyright 2019. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: 800-555-5629 Fax: 973-244-7333 Email: info@maxlite.com
Operating Instructions PH Series
MaxLite PhotonMax LED Green House Luminaire
®
Disconnect the power by turning off the circuit breaker or by removing the appropriate fuse at the
fuse box. Turning the power off using the light switch is not sufficient to prevent electrical shock.
1.
Run the chain link through both v-hooks and hook them onto the fixture through the slots and holes (
Fig. 1
).
2.
Locate a secure structural member and inspect it for damage. Secure the chains around the member and lock it with
the S-hook (
Fig. 2
).
Installation: C-Clip Mounting
Disconnect the power by turning off the circuit breaker or by removing the appropriate fuse at the
fuse box. Turning the power off using the light switch is not sufficient to prevent electrical shock.
1.
Slide the c-clips into the slots at the top of the fixture (
Fig. 1
).
2.
Use the slots at the top of the c-clips to fit a screwdriver and fasten the screws to the fixture (
Fig. 2
).
3.
Use the c-clips to hang the fixture from a strut channel. Ensure that the clips are secured to the strut with nuts and bolts.
Page: 3
REV: 1/02/19
Note:
Ensure a 2 foot minimum required distance between the adjacent lighting equipment and between the
lighting equipment and combustible materials such as walls, ceilings, movable partitions, etc.
