Installation: Aircraft Cable Mounting
© Copyright 2019. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: 800-555-5629 Fax: 973-244-7333 Email: info@maxlite.com
Operating Instructions PH Series
MaxLite PhotonMax LED Green House Luminaire
®
Disconnect the power by turning off the circuit breaker or by removing the appropriate fuse at the
fuse box. Turning the power off using the light switch is not sufficient to prevent electrical shock.
1.
Locate a structural member and inspect it for damage. Secure the aircraft cable around the member and run it through
the gripper to fasten it. The cable enters and exits through the side of the gripper.
Adjust the fixture height by drawing the cable through the gripper (
Fig. 1
).
2.
Secure the bottom aircraft cable into the luminaire by inserting the toggles through the 0.375” hole (
Fig. 2
)
Gripper
Structural Member
Page: 4
REV: 1/02/19
