Hardware Reference
MCD EPOS 60 W
December 2011 Edition / document number 791272-04 / subject to change
maxon motor control
An external supply voltage has to be applied for supplying the digital
optical-isolated outputs.
+V Opto IN
[+V Opto IN]
Connector [J1] Pin number [11]
Common signal
[IN_COM]
Connector [J1] Pin number [10]
Any available power supply can be used, provided it meets the minimal
requirements set below.
Supply voltage
+12…+24 VDC
Min. current *
700 mA
* If maximum load of digital outputs is required