Hardware Reference
MCD EPOS 60 W
December 2011 Edition / document number 791272-04 / subject to change
maxon motor control
Installation and starting of the equipment shall only be performed by experienced,
skilled personnel.
The user must ensure that the compact drive and the components belonging to it
are assembled and connected according to local statutory regulations.
For primary operation the compact drive should be free running, i.e. with the load
disconnected.
Any electronic apparatus is, in principle, not fail-safe. Machines and apparatus
must therefore be fitted with independent monitoring and safety equipment. If the
equipment breaks down, if it is operated incorrectly, if the control unit breaks down
or if the cables break, etc., it must be ensured that the drive or the complete
apparatus is kept in a safe operating mode.
Repairs may be made by authorized personnel only or by the manufacturer.
Improper repairs can result in substantial dangers for the user.
During installation of the MCD EPOS 60 W, make sure to disconnect all apparatus
from the electrical supply.
After switch-on, do not touch any life parts!
Make sure that the supply voltage is between 12 and 50 VDC. Voltages higher than
55 VDC or of wrong polarity will destroy the unit.
