Installation manual
Liftgate GPC 22 X-1, Series 11
Document no.: S 20 912 436
33
Version 2021
Adjusting the platform inclination Series 11 (Tilt sensor programming)
Platform tilt is adjusted by programming the tilt sensor. The tilt sensor is programmed by
pressing a combination of buttons on the control panel
NOTICE
This version of platform harness is not compatible with former versions.
2
1
IMPORTANT
After installation or repair of the liftgate:
-Drive the platform the horizontal position
-press button 1 (upper left) three times, then
-press button 2 (upper right) three times
IMPORTANT
Each of the programming sequences with button 1 and then button 2 must be completed within a
period of 2 seconds. The flashing-light switches off for 5 seconds and indicates the success of
the programming.
The selected position will continue to be used each time the liftgate is operated until the sensor is
reprogrammed.
Summary of Contents for GPC 22 X1
Page 2: ......