Installation
45
4.15 Mounting the license plate holder
Mount the license plate holder below the license plate light.
IMPORTANT:
When positioning the holder, make sure the license plate is sufficiently
illuminated.
4.16 Mounting the bridge plates (20 909 431)
Fasten the bridge plate with the non-skid coating (2) on the right side. The non-
skid coating must face upward when the bridge plate is folded shut (see Fig. 70).
Fasten the non-coated bridge plate (1) on the left side (see Fig. 70).
Legend:
Item 1
Bridge plate
Part No. 20 911 718
Item 2
Bridge plate
Part No. 20 911 699
4.17 Mounting the warning flags
Remove the warning flag kit (14, Part No. 60 710 330) from the accessories kit
and mount it in accordance with the installation instructions below (Fig. 71,
Fig. 72, and Fig. 73).
Required material from accessories kit
IMPORTANT:
Mounting specifications: Comply with
these mounting specifications
(see Fig. 71):
Dimension
A
– Move the holder far enough away from
the tip of the platform to leave 20 mm clearance
between the holder and the ground when the platform is
lowered. The holder must not touch the ground when the
platform is lowered.
Dimension
B
– Position the warning flag as close as
possible to the outside platform edge.
Item
No.
Part No.
Description
Standard
Qty.
14
60 710 330
Warning flag
Kit
1
Fig. 70
Fig. 71
Summary of Contents for GPC X1-LDF
