Adjusting the liftgate
53
5.5 Setting the end stop for the closed platform
The end stop for the platform in the closed position is mounted on the closing arm.
The platform requires no additional stops on the vehicle.
IMPORTANT:
Adjust the platform so that it stands vertically behind the vehicle when
closed and in the driving position.
L
o
o
s
e
n
t
h
e
2
s
c
r
e
ws (1) on the clamping plate (2) (see Fig. 81).
Hydraulically close the platform
until not quite vertical, leaving it
open 3° to 4° (see Fig. 82).
Fig. 81
Fig. 82
3°- 4°
Summary of Contents for GPC X1-LDF
