19
Never move the vehicle unless the Liftgate is properly stowed.
6.
Before moving the vehicle,
prepare the Liftgate as fol-
lows. Make sure load is
removed from platform. If
platform is at bed level, lower
the platform to ground level
as follows. Hold the external up-
down toggle switch in the
DOWN
position
(FIG. 19-1)
until platform
is on the ground
(FIG. 19-2)
.
WARNING
!
7.
Ensure retention ramps
are stowed.
(See LOADING
OR UNLOADING PLAT-
FORM.)
Then, fold the fl ip-
over
(FIG. 19-3)
.
Never operate control switch
while folding the fl ipover.
WARNING
!
PLATFORM LOWERED TO GROUND
FIG. 19-2
FOLDING FLIPOVER
FIG. 19-3
FLIPOVER
NOTE:
If necessary, release the toggle switch to stop the platform
from moving.
DOWN SWITCH
FIG. 19-1
UP-DOWN
TOGGLE SWITCH
Summary of Contents for GPSLR Series
