16
OPERATION - Continued
MOVING TO RETENTION POSITION
(RH VIEW OF FLIPOVER)
FIG. 16-1
MOVING TO RAMP POSITION
(RH VIEW OF FLIPOVER)
FIG. 16-2
6.
Continue to pull retention ramp
to the retention position
(FIG.
16-1)
and then to ramp posi-
tion
(FIG. 16-2)
.
PULL
CAUTION
!
RAMP
RETENTION
To prevent injuries, stay
clear of the retention ramp
path as it is moved to ramp
position. Go to either side
of the ramp and stay out of
the way.
LOADING PLATFORM AT GROUND
LEVEL (RAMP POSITION)
FIG. 16-3
7.
Load the platform at
ground level as follows.
Make sure retention ramps
are in the ramp position
(FIG. 16-3)
. Next, move
carts on the platform as
shown in
FIG. 16-3
.
If platform is equipped
with cart dishes, ensure
the rear wheels of each
cart are seated in the
dishes.
WARNING
S
!
A load should never extend past the edges of the platform. Do not
place unstable loads on platform and do not allow load to exceed
the lifting capacity of the Liftgate. If standing on platform, do not
allow your feet to extend beyond the inboard edge of the platform.
RETENTION
RAMPS
Summary of Contents for GPSLR
