22
Never move the vehicle unless the Liftgate is properly stowed.
15.
Before moving the vehicle,
prepare the Liftgate as
follows. Make sure load
is removed from platform.
If platform is at bed level,
lower the platform to ground
level as follows. Hold the
Enable operation
switch in
the on position
(FIG. 22-
1)
. Then, hold the external
toggle switch in the
DOWN
position
(FIG. 22-1)
until
platform is on the ground
(FIG. 22-2)
.
.
WARNING
!
OPERATION - Continued
16.
Ensure retention ramps
are stowed.
(See step 14.)
Then
, f
old the fl ipover
(FIG. 22-3)
.
Never operate control switch
while folding the fl ipover.
WARNING
!
PLATFORM LOWERED TO GROUND
FIG. 22-2
ENABLE SWITCH & DOWN SWITCH
FIG. 22-1
FOLDING FLIPOVER
FIG. 22-3
ENABLE
SWITCH
TOGGLE
SWITCH
FLIPOVER
NOTE:
If necessary, release the
toggle switch to stop the
platform from moving.
Summary of Contents for GPSLR
