In User Manual
- 54 -
END
The following SNMP trap events are also supported:
-
Authentication incorrect password
-
Authentication incorrect username
-
Maximum session timeout expired
Note: SNMP events are reported in SNMPv2, however SNMP access can be either
SNMPv2 or SNMPv3.
SNTP
SNTP can be used to update the time of the In. The modem will by default take
its time from the network. When SNTP is enabled, the modem will query a network-
based NTP server using the SNTP protocol and pull the time from it. The timezone can be
configured depending on where in the world the modem is used. If the daylight savings
setting is configured the modem will add an additional 1 hour to the system time setting.
If SNTP is not configured correctly or the server is not available then it can cause the
system logs to incorrectly record as they are referenced to system time. The minutes
configuration can only be set to 30 minutes.
Summary of Contents for MA-2020
