In User Manual
- 60 -
SMS Syntax:
INTELIMAX.PARK.DDNS1 <mode 1-enable 0-disable>(,<host address>)
e.g. INTELIMAX.PARK.DDNS1 1,dyn.com
INTELIMAX.PARK.DDNS2 <domain name>,<user id>,<user password/key>
e.g. INTELIMAX.PARK.DDNS2 inte.dyndns.biz,maxon,max@123
SMS Commands (Serial modem modes)
The Reboot In SMS command can be used to act on In specific SMS
messages when in serial modem mode. For this to happen the modem must be told to
intercept the SMS messages using the AT$$STEALTHSMS command.
AT$$STEALTHSMS?
$$STEALTHSMS: 0
OK
AT$$STEALTHSMS=0
– disable modem interception of SMS messages
OK
AT$$STEALTHSMS=1
– modem to intercept SMS message
OK
Reboot In
SMS Syntax:
INTELIMAX.PARK.REBOOT
RSSI Info
SMS Syntax:
INTELIMAX.PARK.RSSI
Reply message
syntax:
RSSI <value> e.g. RSSI -57
Change mode via SMS
SMS Syntax:
INTELIMAX.PARK.CHGMODE <1(IPStack Auto)/2(IPStack Manual)/3(Serial Modem)>
e.g. INTELIMAX.PARK.CHGMODE 1
Reply message syntax:
Mode Change To <mode>
e.g. Mode Change To IPStack Auto
The modem will automatically reboot after sending the response.
Summary of Contents for MA-2020
