In User Manual
- 86 -
OK
Parameters
$$SYSTS: X,X,X,X,X,X,X,X,X,X,X
UserName
Password
0,1 Telnet Disable/Enable
Telnet Port Number
0,1 Syslog Disable/Enable
0,1 Remote syslog Disable/Enable
Remote syslog server address
0,1 SSH Disable/Enable
Phone number of Administrator
Phone number of Administrator
Phone number of Administrator
OK
maXconnect
To enable maXconnect on the In either use the GUI or enter the following
commands when the modem is in IP Stack Auto mode.
$$MAXCNT: 0,120,portal.maxconnect.com.au,1883,updates.maxconnect.com.au
OK
AT$$MAXCNT=?
$$MAXCNT: X,X,X,X,X
0,1 Disable/Enable
Refresh Interval
Broker URL
Broker Port
FTP update server URL
OK
Serial (UART) port
Serial port settings including number of data bits, parity, and stop bits must be set using
Summary of Contents for MA-2020
