PATENTS PENDING
42
11921 Slauson
A
ve. Santa Fe Springs, CA. 90670 (800) 227-41
16 F
AX (888) 771-7713
ADJUSTMENTS
MAT SWITCH ADJUSTMENT (IF REQUIRED)
2.
Measure the height of the
threshold plate as shown in
FIG.
42-1B
. If the height is 5/8”,
go to step 4 (skip step 3). If the
height is not 5/8”, go to step 3.
LIFT THRESHOLD
FIG. 42-2A
HEIGHT ADJUSTMENT SCREW
(RH SIDE SHOWN)
FIG. 42-2B
ADJUSTMENT
SCREW
LIFT AT GROUND LEVEL
FIG. 42-1A
POWER SWITCH
HEIGHT MEASUREMENT
(RH SIDE SHOWN)
FIG. 42-1B
1.
Make sure power switch
(FIG. 42-1A)
is turned
on. Lower Lift to the
ground
(FIG. 42-
1A)
.
HEIGHT ADJUSTMENT SCREWS
FIG. 42-3
3.
Set edge of the threshold plate to
5/8” height by turning the adjust-
ment screw on the RH side of
threshold plate
(FIG. 42-2B)
.
Turn adjustment screw counter-
clockwise
(FIG. 42-3)
to raise
threshold plate or clockwise to
lower. Repeat for LH side of
threshold plate. Alternately mea-
sure height (see instruction 2).
Then, turn the adjustment screw
on RH side and LH side until the
entire edge of threshold plate is at
5/8” height.
CCW - RAISE
CW - LOWER
5/8”
Summary of Contents for WL7-vers. C
Page 2: ...PATENTS PENDING...
Page 3: ...PATENTS PENDING THIS PAGE INTENTIONALLY LEFT BLANK...
Page 61: ......
