4
GB
4) Power tool use and care
a) Do not force the power tool.
Use the correct power tool for your applica
The correct power tool will
do the job be er and safer at the rate for which it was designed.
b) Do not use the power tool if the switch does not turn it on and o
ff
.
Any power tool that cannot be
controlled with the switch is dangerous and must be repaired.
c) Disconnect the plug from the power source and/or the ba ery pack from the power tool before
making any adjustments, changing accessories, or storing power tools.
Such preven ve safety measures
reduce the risk of st
ower tool accidentally.
d) Store idle power tools out of the reach of children and do not allow persons unfamiliar with the power
tool or these ins
to operate the power tool.
Power tools are dangerous in the hands of untrained
users.
e) Maintain power tools.
Check for misalignment or binding of moving parts, breakage of parts and any
other condi
that may a
ff
ect the power tool’s opera
If damaged, have the power tool repaired
before use. Many accidents are caused by poorly maintained power tools.
f) Keep cu
tools sharp and clean.
Properly maintained cu
tools with sharp cu
edges are less
likely to bind and are easier to control.
g) Use the power tool, accessories and tool bits etc.
in accordance with these ins
taking into
account the working co
s and the work to be performed. Use of the power tool for opera
s
di
ff
erent from those intended could result in a hazardous situa
5) SERVICE
a) Have your power tool serviced by a
qualified
repair person using only iden cal replacement parts.
This
will ensure that the safety of the power tool is maintained.
SAFETY INSTRUCTION FOR DRILL PRESS
Symbols
Danger Area! Keep hands far away from the cu
rea while the machine is running.
Keep bystanders away.
1) TOOL USE
DON’T FORCE TOOL
It will do the job be er and safer at the rate for which it was designed.
USE THE RIGHT TOOL
Don’t force a small tool or a achment to do the job of a heavy duty tool. Don’t used tool for purpose not
intended—for example, don’t use a circular saw for cu
ree limbs or logs.
SECURE WORK
Use clamps or a vise to hold work. It’s safer than using your hand and it frees both hands to operate the
tool.
NEVER LEAVE TOOL RUNNING UNATTENDED
Turn power o
ff
. Don’t leave tool un
comes to a complete stop.
2) TOOL CARE
DO NOT ALTER OR MISUSE TOOL
These tools are precision built. Any altera
or modi
fi
ca
not spec
ifie
d is misuse and may result in
