background image

7

Appendix B - FCC Notice

FCC Compliance Statement

This product has been tested and found to comply with the limits for a Class B
computing device pursuant to Part 15 of the FCC rules. Installed correctly, it prob-
ably will not interfere with radio or TV reception. However, we do not guarantee the
absence of interference.

This product generates and uses energy of about the same frequency as radio
and TV broadcasts. Installed incorrectly, it may interfere with reception of radio
and TV broadcasts.

NOTE

This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.

CAUTION

If the device is changed or modified without permission from MaxTech, the user
may void his or her authority to operate the equipment.

Appendix C - CE Mark Declaration of Conformance

This is to certify that this product complies with ISO/IEC Guide 22 and EN45014.
It conforms to the following specifications:

EMC:

EN55022(1988)/CISPR 22(1985)

Class B

EN60555-2(1987)

Class A

prEN55024-2(1990)/IE801-2(1991)

4KV CD, 8KV AD

prEN55024-3(1991)/IE801-3(1984)

3V V/m

PrEN55024-4(1992)/IE801-4(1988)

1KV - (power line)

0.5KV - (signal line)

This product complies with the requirements of the Low Voltage Directive 73/23/
EEC and the EMC Directive 89/336/EEC.

Appendix D - Two Year Limited Warranty

MaxTech warrants to the original buyer of this product against defects in material
and workmanship for two years from the date of purchase. During the warranty
period, MaxTech will repair (or at its option, replace) the product that proves to be
defective, provided the product has not been abused, misused, modified, or re-
paired by an unauthorized center.

In the event the product requires service, follow the procedure outlined in 

Techni-

cal Support. When you are instructed by the Technical Support Representative to
return the product to MaxTech for repair, you will be given an RMA (Return Mer-
chandise Authorization) number. You

 must have an RMA Number to return the

Summary of Contents for FHX-1200











Reviews: