9
32-bit (PCI) adapter can only function with 32-bit
versions of the EMM386.EXE memory manager
program (version 4.49 or later). You can verify its
version by entering EMM386 at the DOS prompt.
Do not specify the “highscan” option with the
EMM386.EXE statement in your CONFIG.SYS file
or your system will hang.
If you run MEMMAKER and select Custom Setup,
do not specify “Aggressively scan upper memory,”
or it will automatically insert the HIGHSCAN flag
into the EMM386 command line. This parameter
cannot be removed once it is installed. Doing so will
cause the extended memory manager to malfunc-
tion.
3.1 Windows 95 Driver Installation
Note: Windows 95 identifies most add-on cards
based on the chipset used. The MaxTech Ethernet
adapters use the Realtek Ethernet chipset and will
be identified as such.
When Windows 95 starts for the first time after card
installation, it detects the adapter as a “PCI Ethernet
Controller” card. If Windows displays the New
Hardware Found dialog box, proceed to Section
3.1.1. If Windows displays the Update Device
Driver Wizard, proceed to Section 3.1.2.
3.1.1 Windows 95 Release 4.00.950
Under New Hardware Found, when asked to
“Select which driver you want to install for your new
hardware,” click on “Driver from disk provided by
hardware manufacturer.” Click “OK.”
The Install From Disk dialog box now instructs
you to “Insert the manufacturer's installation disk
into the drive selected, and then click OK.” Insert
the adapter's driver diskette and type A:\WIN95 (or
B:\WIN95 if inserted in drive B) in the “Copy
manufacturer's files from:” box. Click “OK.”
The Select Device dialog box presents the selec-
