10
Installing coaxial cables
1. Check there are no hidden cables in the roof structure and that the hole location is clear
of obstructions both internally and externally.
2. Drill a 8mm hole to pass the satellite cable. For 2 cables, drill 2 holes or use larger drill.
3. Clean off any burrs from the hole and clean surface.
4. Pass cables through the hole.
5. Using adhesive bond cable entry plate to the roof – note the 3 cable glands should face
the rear of the vehicle.
6. Secure cable to roof using the cable clips (supplied).
7. Inside the vehicle route cable to satellite receiver and make the F connection.
The Crank Up satellite system features a twin LNB for connection to a PVR or 2 separate receivers.
Use an extra Cable Entry Plate to route the
2nd Sat feed to a different location.
Note
To prevent trip hazards it is recommended that cables are concealed in PVCu conduit
(not supplied) where access is required to the roof of the vehicle.
CRANK UP NZ INSTRUCTIONS MASTER.indd 10
17/09/2013 13:01