9
11. Place a small amount of adhesive
into each pilot hole before screwing
plate to roof.
12. Wipe off excess adhesive with a cloth.
Important Note:
• Follow manufacturer’s instructions
when applying adhesive. Do not travel
until adhesive has cured noting that
curing times vary with weather
conditions.
• Take care when working at heights.
Always follow ladder safety advice.
• Use creeper boards where necessary
to ensure roof construction can
support your weight.
• Power tools should be used in
accordance with manufacturer’s
instructions.
Attach Antenna Unit to Mounting Plate
Carefully lower the antenna unit onto the Mounting Plate and re-attach the M6 Nuts and Washers
that were previously removed.
Important Note:
DO NOT REMOVE
transit tape x 2
Caution
Replace Nylon locking nuts if they have been removed more than twice. The locking action of the
Nylon becomes less effective if repeatedly assembled and disassembled.
7 x No.
10 screws
(large)
CRANK UP NZ INSTRUCTIONS MASTER.indd 9
17/09/2013 13:01
