Maxview MXL040, Setup And User'S Manual

Using your Sat Finder

Your Sat Finder is used to help you locate and find the best signal quality received from satellites.

Tune the sat finder by turning the knob fully anti-clockwise and then slowly clockwise until 2-3 red LEDs are lit. 
Slowly rotate the dish from left to right until more LEDs light up. 

You should now have a picture on your TV.

Please note if your LEDs light up on your sat finder and you are receiving no reception, you may have located a 
different satellite as the sat finder is unable to distinguish between different satellites. If this happens, repeat 
the above process, searching a slightly different area and dish angle.

Also ensure your receiver box is set to the correct satellite.

Fine tuning using the Sat Finder. 

Once a picture has been found, turn the sat finder down until 2-3 red LEDs 
are lit and finely adjust your elevation and azimuth to improve your
signal and more LEDs light.

Using the receiver Sat Finder.

Firstly, ensure your sat finder is turned off by turning 
it fully anti-clockwise so only the green light shows.

Turn your box onto the correct satellite (e.g. Astra 2 for UK)
and bring up the satellite finder menu. (see receiver instructions).

Slowly rotate the dish from left to right until the signal 
quality and intensity increases.

Fine tuning using the receiver sat finder.

Once a picture has been found, bring up the satellite finder menu and 
finely adjust your elevation and azimuth controls to improve your signal quality and intensity.

ASTRA 2 (UK TV)