SYMPTOM
The power inserter light
does not come on.
Solid dim orange light
on power inserter.
Flashing red and blue
continuously
Power inserter indicates a
satellite has been found
with a solid LED
light after searching;
however my TV has no
picture.
POSSIBLE CAUSE
No power to the Power Inserter.
The satellite could not be located,
reasons for this include:
A line of sight obstruction between
the antenna and the satellite.
(Maybe due to incorrect orientation
of handle)
Surface may be too uneven for the
VuQube II to overcome.
Surface may be unstable.
Problem with connection between
power inserter, receiver or TV.
Error with your F to F lead
connection between the antenna
and the control box.
Receiver isn’t set to correct satellite.
CAUSE OF ACTION
Verify power supply is properly
connected to VuQube II Power
Inserter.
Move unit to have a better view of
the Southern sky and rescan.
Inclement weather can occasionally
cause loss of signal. Wait till weather
improves and re-scan.
Move the unit to flatter ground and
re-scan.
Move unit to a more stable surface
to ensure it doesn’t move whilst
scanning.
Power off, check connections, power
on and re-scan.
Ensure the ‘F’ lead is properly
connected using the diagram on
page 5.
Turn off power inserter, ensure cables
are properly connected between
receiver and/or TV.
Set receiver to correct satellite
using receiver manufacturers owners
manual.
Troubleshooting
14
Weight:
3.5kg
LNB:
Universal 10.7-12.75 GHz/Noise 0.2dB
CB Power
Consumption
(typical at 12V):
Searching =500mA
Elevation Range:
18° to 43°
Dish Size:
35 cm
Dish Gain:
30dBi
Specifications
Summary of Contents for VuQube II MXL023G
Page 19: ......
