9
enGlISH
are near the vacuum cleaner suction open-
ing.
•
Close supervision is necessary while cleaning
the stair landings.
•
Do not use the vacuum cleaner for collecting
of such inflammable liquids as gasoline and
solvents; do not use the unit in the places
where such liquids are stored.
•
Do not use the vacuum cleaner for collecting
water and other liquids, burning or smoking
cigarettes, matches, cinders as well as fine
dust, for example, of plaster, concrete, flour
or ashes.
•
Do not use the vacuum cleaner if:
– the dust container is not installed or improp-
erly assembled;
– inlet and outlet filters are not installed.
– Make sure regularly that the power cord and
the plug are not damaged. Do not try to repair
the unit by yourself. Contact the authorized
service center for all repair issues.
THE UNIT IS INTENDED FOR HOUSEHOLD USAGE
ONLY
assembling the vacuum cleaner
Unpack the vacuum cleaner completely and
check it for damages. Do not use the unit in case
of damages.
Note:
•
In case of unit transportation or storage at
low temperature it is necessary to keep it
for at least two hours at room temperature
before switching on.
•
Before using the unit, make sure that your
home mains voltage corresponds to the volt-
age specified on the vacuum cleaner body.
•
Always switch the vacuum cleaner off and
unplug it while replacing the brush attachments
and before cleaning the dust container (9).
attaching the flexible hose, the telescopic
pipe and the attachments
– Insert the flexible hose ending (12) into the
air inlet (10), matching the clamps with the
grooves in the air inlet (pic. 1).
– Turn the flexible hose ending (12) clockwise
till bumping. To remove the flexible hose (13)
turn the ending (12) counterclockwise.
– Insert the flexible hose handle (14) into the
telescopic extension pipe (16) (pic. 2).
– Extend the lower part of the telescopic
extension pipe to the required length, having
preliminary pressed the lock (17).
– Select the required attachment: floor/car-
pet brush (18) or crevice nozzle (20) - and
attach it to the telescopic extension pipe
(16) (pic. 3).
– Crevice nozzle (20) can be attached directly
to the flexible hose handle (14).
using the brush attachments
Floor/carpet brush (18)
Set the switch (19) to the required position
(depending on the type of the surface being
cleaned).
crevice nozzle (20)
The crevice nozzle is intended for cleaning of
radiators, chinks, corners and spaces between
cushions.
OPeraTIOn
Safety measures
•
Do not use the vacuum cleaner near hot
surfaces, ashtrays and in the places where
inflammable liquids are stored.
•
Take sharp objects away from the floor
before cleaning to prevent unit damage.
•
If the suction power of the vacuum cleaner
has dramatically decreased while cleaning,
switch it off immediately and check the tele-
scopic pipe and the flexible hose for obstruc-
tion. Switch the vacuum cleaner off, unplug
it, remove the obstruction and after that you
can continue cleaning.
Attention! Always switch the vacuum cleaner
on only with dust container (9) and inlet (4)
and outlet (23) filters installed. Always make
sure that the filters are installed properly.
– Before using the unit, unwind the power cord
to the required length and insert the plug
into the socket. Yellow mark on the power
cord indicates the maximum cord length. Do
not unwind the power cord further than the
red mark.
– Press the button (1) to switch the vacuum
cleaner on.
– During the operation you can control the
suction power by turning the power control
MW-3221.indd 9
19.11.2013 10:36:56
Summary of Contents for MW-3221 OG
Page 1: ...Пылесос MW 3221 R OG Y 4 8 12 16 20 24 28 32 36 MW 3221 indd 1 19 11 2013 10 36 50 ...
Page 2: ...1 6 7 2 3 5 9 8 12 11 13 14 15 16 17 18 19 10 4 MW 3221 indd 2 19 11 2013 10 36 52 ...
Page 3: ...рис 1 рис 6 рис 4 рис 2 рис 5 рис 3 21 22 23 24 25 26 27 MW 3221 indd 3 19 11 2013 10 36 54 ...
