5
-------SPECIFICATIONS
• Voltage (VAC): 120
• Frequency (Hz): 60
• Fan Amps: 2.1
• Total 3.6 Amps
• CFM: Up to 3500 (High)
• Speeds: Hi/ Med/ Low
• Model# CDMPl 840GRY: 18"fan head, 180 psi pump, 40 gal cooler case, pumps out 3 gph
• Model# CDMPl 810 :
18"fan head, 180 psi pump, 10 gal cooler, pumps out 3 gph
• Model# CDHPl 840GRY: 18"fan head, 1000 psi pump, 40 gal cooler case, pumps out 3.5 gph
• Misting Ring: Stainless steel
• Filter: 50 mesh stainless steel strainer
• Water Supply POTABLE ONLY
6
,-----GETTING STARTED (ALL UNITS)
1. Take empty cooler to location desired to be cooled.
2. Fill cooler with clean water.
**Less water results in less run time.
3. Place the fan/pump enclosure on the cooler.
4. Make sure the intake line and filter are in the bottom of the cooler.
5. Follow specific unit instructions.
7
*
Note: these models use the same fan and pump,
MID PRESSURE UNITS
only the cooler is different
1. Follow the directions in the "Getting Started" section
2. Aim mister downwind for best results. If more than one mister is used, arrange them in an arc
3. Plug the GFCI safety plug into any 120 VAC 60 Hz ground outlet
4. Test the GFI
a. Plug into outlet. Indicator will show if power is available.
b. Press the test button. Indicator will turn off.
5. The misting ring located in the center of the fan is equipped with nozzles. The output volume of
water can be reduced by replacing some of the nozzles with plugs. Adjust nozzles for the
desired output level.
6. After use, drain the cooler case of water and store fan inside (CDMP1840GRY).
**CDMP1810 fan will mist for approximately 4 hours
**CDMPl 840GRY fan will mist for approximately 13 hours.
