3
Installation Information
WARNING:
•
Instruct all personnel in the proper use of the equipment.
•
Clean up any liquid spills immediately.
Unpacking
Unpacking the ice dispenser can be done by cutting the bands that are holding the cardboard box
to the shipping pallet. The box can then be lifted vertically to expose the machine.
Remove all packaging materials from the ice dispenser and protective film from the stainless steel
surfaces.
Carton Contents
•
Maxx Ice MID200 Series Ice Dispenser
•
Leg kit.
•
Installation & Operation Manual. Leave these with the owner/user.
•
Ice machine mounting hardware, gasket and wiring components for thermostat connection.
Installation Requirements
The ice dispenser must be installed indoors. Do not install the dispenser in an unprotected
outdoor area or any wet area.
Note:
Consult ice machine instructions for proper installation requirements, before
determining the location of the ice dispenser.
Installation site ambient temperatures below 90°F (32°C) are recommended for proper
operation. Higher than this maximum specification will result in increased melting of ice in the
dispenser. Also avoid areas near a heat source or in direct sunlight.
