SWING DOOR REPLACEMENT AND ADJUSTMENT
1 Open the bottom shroud and hold the door, then loosen the bottom hinge’s screws and take off
the old door
2 Prepare new door, insert top pin into top hinge, get one bottom hinge to hold the door by the
bottom pin, then fasten bottom hinge securely to the door frame with three screws;
3 Allow the door to freely swing, make sure it swings closed by itself with no restriction
4 Plug the unit in and make sure the lock works well;
5 If not, adjust the door height by adding the plastic spacer/washer provided to the bottom hinge
pin
SLIDING DOOR REPLACEMENT AND ADJUSTMENT
1 Take off the hook of counterweight of door from top of the door;
2 Hold the door up until it’s bottom edge is over the bottom channel, move the door out across the
channel and lay the door down;
3 Prepare new door, hold the door insert into top channel until bottom edge is over the bottom
channel, move bottom of door across the channel wall and set it down in to the channel
REMOVE THE BOTTOM SHROUD
Loosen and remove the top screws, slide the shroud up and out
LIGHT BULB REPLACEMENT
1 Upper light bulb replacement: Loosen the screws in the bottom of top shroud, swing the top shroud
up until it is held by the top of the cabinet, now the light bulb can be replaced;
2 LED light bulb replacement: Take the cover off, then the LED bulb can be replaced
9
SAFETY PRECAUTIONS:
1.This refrigerator must be properly installed and located in accordance with the Installation Instruc-
tions before it is used.
2.Do not allow children to climb, stand or hang on the shelves in the refrigerator. They could damage
the refrigerator and seriously injure themselves.
3.Do not touch the cold surfaces in the freezer compartment when hands are damp or wet. Skin may
stick to these extremely cold surfaces.
4.Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any
other appliance.
5. Keep fingers out of the "pinch point" areas; clearances between the doors and between the doors
and cabinet are necessarily small; be careful closing doors when children are in the area.
NOTE: We strongly recommend that any servicing be performed by a qualified individual.
- Unplug the refrigerator before cleaning and making repairs.
- Setting temperature controls to the ZERO (0) position does not remove power to the light circuit,
perimeter heaters, or evaporator fans.
Refrigerant Disposal
Your old refrigerator may have a cooling system that uses "Ozone Depleting" chemicals. If you are
throwing away your old refrigerator, make sure the refrigerant is removed for proper disposal by a
qualified service technician. If you intentionally release any refrigerants you can be subject to fines
and imprisonment under provisions of the environmental regulations.
