Page | 13
Additional Functions:
1.
Draining Function:
press the “Clean” button and hold for 6
seconds, the machine will go into the draining water mode
automatically. The words of “Purging Water” appear on the
LCD screen. The words disappear after 3 minutes and the
draining process stops.
NOTE:
Draining function only effect in
“Water Fill” process and “Cleaning” process.
2.
Self-checking Function:
when the ice maker runs, the control board will check the
condenser probe, evaporator probe, high condenser temperature, water shortage, long
freeze, long harvest and water curtain function, if one of them defaults, the
exclamation mark will appear and blink on the left bottom corner of the LCD screen. At this
time press “ADJUST” button, the cause of default will appear on the LCD screen. See photo
below.
3.
Purging cycle interval Optional Function:
during “Water Fill”
process, press and hold the “CLEAN” button and “ADJUST”
button together for at least 3 seconds. The unit will enter the
“Purging Optional” process, the words of “Purging Optional”
and “20 Cycle” (Note: The cycle number may display other
number) appear on the LCD screen. During this period, you
can press the “MODE” or “CLEAN” button for the desired purging cycle interval. You can
choose any purging cycle interval from 0 to 20.
4.
After 10 seconds without any operation, the unit will automatically memorize the current
status and return to the previous process.
NOTE:
The machine is only in “Water Fill” process, the purging cycle interval Optional Function can be
accessed.
IMPORTANT:
The purging cycle interval 20 has been set at the factory for optimum
performance. You can change it according to the quality of water.
ICE BRIDGE SIZE ADJUSTMENT GUIDE:
1
Press and hold the “ADJUST" button for at least 3 seconds The unit will enter the Ice Size
Adjustment mode and the words "Ice Adjust" display on the LCD Screen.
2
While in the Ice Size Adjustment mode, press the “Clean” button or the “Mode” button for the
desired ice size.
SMALLER ICE SETTING:
By pressing the “Clean” button, you can decrease the size of the ice bridge The words of "-6
Minutes" indicate the smallest ice size
LARGER ICE SETTING:
By pressing the “Mode” button, you can increase the size of the ice bridge The words of "+10 Minutes"
indicate the largest ice size.
After 10 seconds without any operation, the unit will automatically
memorize the current state and return to the previous mode.
NOTE:
•
If during the ice size adjustment mode the words of “Ice Adjust” and “0 Minute” display on the LCD
screen, this indicates that the unit is in the regular (middle) setting of the ice size.
•
When the machine is in the cleaning stage or ice full stage, the ice size adjustment mode cannot be
accessed
IMPORTANT:
•
The ice bridge adjustment has been set at the factory for optimum performance and it is not
recommended for a user to make this adjustment This ice adjustment procedure should therefore be
made only by an authorized service technician
IMPORTANT:
•
Although the unit has been tested and cleaned at the factory, due to long-term transit and storage,
the first batch of cubes must be discarded.
•
Never turn the water supply tap off when the ice maker is working.
•
Never touch the evaporator when the machine is running.
•
Keep the door closed as much as possible to reduce melting and insure proper ice formation.
