STEP 6
The interior Garnish Trim Ring must be trimmed
to fit your particular RV roof thickness. To
accomplish this, measure the distance from
the vehicle ceiling surface to each corner of the
MAXXFAN
Control Plate.
Most RV roofs have some slope, so measuring
each corner is necessary. The Garnish ring
should be cut 1/4” to 1/2” longer than the
dimensions measured at each corner.
In Picture #6 to the right, the installation measures
3 and 1/2” from the ceiling (this is an example
only) to the Control Plate. After adding 1/2” as
in this example, using a ruler, place a mark at 4”
on each corner of each side of the Garnish Ring
(refer to 6A below). Once marked, draw a line
connecting all 4” markers on the outside of the
Garnish ring and trim accordingly (refer to 6B to
the right).
STEP 7
Complete the installation by placing any excess
wiring to the inside of the roof opening and sliding
the Garnish Ring into position. Fasten in place by
using the four painted flat head screws provided.
NOTE:
DO NOT probe or tamper with the thermostat
sensor or IR sensor shown in illustration #6 above.
MEASUREMENTS STATED
IN STEP 6 ARE USED AS AN
EXAMPLE FOR ILLUSTRATION
PURPOSES ONLY
7
CONGRATULATIONS!!!
You have successfully completed the
installation of your new
MAXXFAN
.
If you have questions, please visit
Airxcel.com or call us at 316-832-4357.
FOR REMOTE CONTROL MODELS:
Attach the included cradle to wall with (2) #6
screws provided. Handheld Remote Control may
be placed into wall cradle for storage.
6A
GARNISH RING
6B
GARNISH
RING
6
IR RECEIVER
3 1/2”
CEILING
3
