EN
12
■
Lay the connecting cable in such
a way that it does not become
squashed or kinked and does not
come into contact with hot surfaces.
It is essential that you charge
up the battery fully before you
fi rst use the device in order to
achieve the maximum charging
capacity. If the battery is fully
discharged during use, it must be
fully charged up again before it is
next used.
1. Connect the USB cable (
3
) to the
connecting socket (
4
) of a cuff (
1
) and
to the connecting socket of the USB
mains adapter.
2. Only then should you connect the
mains adapter to an easily accessible
socket.
The lamp (
8
) in the control unit lights
up red. The battery is charging.
3. When the control lamp lights up
green
, the battery is fully charged.
4. First disconnect the mains adapter
from the power supply and then the
USB cable from the mains adapter
and the cuff.
USE
Please Note!
■
A tingling sensation / itching during
or after the massage is normal due to
the circulation-boosting effect.
■
Do not use the cuffs for longer than 20
minutes without a break.
Start with the slowest level and
gradually increase the level of
intensity.
1. Place the cuffs (
1
) around the arms,
feet or legs (
Fig. B
) and fasten them
with the kook-and-loop fasteners (
5
).
Make sure that they are not applied
too tightly so that they do not be-
come too tight during operation.
2. Press the
On/Off switch (
7
) on the
control unit to activate the massage.
The control lamp (
8
) lights up.
The air chambers in the cuffs are slow-
ly infl ated in two stages and emptied
again after a few seconds.
3. Depending on your requirements, set
a higher level using the +/- switch (6).
Please Note: When switched off and
on the massage starts again at the
lowest level.
4. After 10 minutes the massage stops
automatically. It can be stopped at
any time by pressing the
On/Off
switch.
The cuffs should not be used be-
fore going to sleep. The massage
has a stimulating effect, which
may lead to problems getting to
sleep.
