3
DRAWING
1. Soft
Handle
2. Bow
Cover
3. D-Ring
4. Adjustable
Seat
5. Paddle
Holder
6. Zipper
7. Valve
8. Drain
Plug
9. Skeg
Base
10. D-Ring for Seat
11. Directional Strake
12. Stern Cover
ASSEMBLY INSTRUCTIONS / INFLATION / DEFLATION
Inflate your
CAYMAN II
with a pump from
EVERGOING PRODUCTS (MAXXON)
or any pump designed for inflatable boats, and
other low pressure inflatables. These types of pump will have a hose and adapters to fit the valves on this kayak.
Choose a smooth and clean surface to unfold your kayak.
1. Attach the skeg on the underside by folding the hull. First partially deflate the kayak. The skeg cannot be installed when the
kayak is fully inflated. The curvature of the skeg must be pointed towards the back end of the kayak.
2. Side tube & Bottom floor valve – please see drawing to the right:
Unscrew the valve cap(1). Screw the valve insert(2) onto its base(3) and (1) Valve cap
check that the valve cap stays accessible. Insert the pump hose end piece
and inflate it until you will reach the required pressure. After inflation tighten (2) Valve insert
the valve cap (clockwise). A slight air-leak before screwing the valve cap is
normal. Only the valve cap can ensure final AIR TIGHTNESS. (3) Valve base
To release air from bottom floor unscrew the valve insert(2) from the valve
base(3).
(3) Valve base
3. Max. air pressure
: the correct pressure for this item is :
0,1 bar/ 1.45 PSI(= 100 mBar ).
Do not exceed it
.
