Maxxus 600354-00019-0001, Installation & Operating Manual

23

ENG

FAQ

My training device makes noises during training – is this normal?

Your MAXXUS® training device is equipped with high-quality ball-bearings and a grooved belt. In addition, it 

also has a high-quality magnetic braking system which is completely wear and friction free. All these extremely 

high-quality components ensure that all functional noises are very much reduced. Your MAXXUS® training de

-

vice is one of the quietest products available in the fitness market. However, it is possible and normal that slight 

mechanical noises are noticeable during training. These mechanical noises, which either continually or some-

times occur at certain intervals are created by the very high rotational speed of the flywheel. Also, moving parts 

may generate sounds during training, which are amplified by the hollow metal tubes of the frame. It is also quite 

normal for running noise to get louder during your workout. This can be explained by an increase in training 
speed and by the device components heating up and expanding during training. 

The cockpit does not show anything in the display when I turn it on.

Check if the power cable is both attached correctly to the device and properly plugged into the socket, and/or if 

it is damaged. Check if the control cable has been pinched or jammed during assembly and / or if the connector 

has come loose.

The pulse rate value is not shown or is indicated incorrectly

Please refer to the „Pulse & Heart Rate Measurement” sections in this manual.

The hand pulse rate sensors are not functioning

Check if the hand sensor cables have been pinched or jammed during assembly. 

The speed and distance values are indicated to be„0“during training.

Check if the control cable has been pinched or jammed during assembly and/or if the connections have come 

loose. 

My training device makes creaking noises during training.

Check if the training device is standing straight and flat on the ground. If not, re-adjust the foot stands. Check if 

the screws at the articulated joint between the pendulum tubes and the pedal arms are tightened securely.

My feet fall asleep during training.

The reason for this is often that training shoes are done up too tightly. Your feet will expand when you are under 
exertion and so you should do up your shoes more loosely. You can also get advice regarding this from sports 
shops or specialist running shoe shops.