Maxxus RunMaxx 7.4 T, Installation & Operating Manual

20

Cockpit

Display of the Training Values

The following values of the training are displayed:

Distance

Specifies the distance travelled during the training session.

Time

                              Indicates the completed training time.

Calories

                                Indicates the kilocalories consumed*

Pulse Rate

                 When using the hand pulse sensors – Indicates the current pulse rate 

                          When using a transmitter chest belt** – Indicates ECG accurate heart rate

Incline 

Indicates the current set incline level

Steps

                              Indicates the number of steps taken

Tempo

                              Indicates the time required for one kilometre

Speed

                              Indicates the current set speed

*Note on calorie measurement 

Energy consumption is calculated using a general formula. It is not possible to determine an individual energy consumption exactly, because a large 
amount of personal data is required for this purpose. The displayed energy consumption is an approximate and not an exact value.

**Note on heart rate measurement

Transmitter chest belt optionally available - MAXXUS recommends the use of a POLAR T34 chest belt.

Further Functions

Hand Pulse Sensors

Used for short-term pulse control. Hold the hand sensors with both hands. After a short time, the current pulse is shown on the display. 

Please also read the sections “Pulse Measurement Using Hand Sensors” and “Warning About Pulse and Heart Rate Measurement” in 

this manual.

Heart Rate Measurement

The cockpit of this treadmill is already equipped with a receiver for wireless heart rate measurement. A transmitter chest belt, not 

included in the scope of delivery, is required for this. This chest belt must transmit at a frequency of 5 KHz and be uncoded. MAXXUS® 

recommends the use of a POLAR® T34 transmitter chest belt. The use of Bluetooth chest belts is not possible.

Please also read the sections “Heart rate Measurement Using Chest Belt” and “Warning About Pulse and Heart Rate Measurement” in 

this manual.

Line-In Connection & Speakers

The cockpit of the treadmill is equipped with a line-in connection and speakers. The line-in cable included in delivery allows you to 

connect an external music source (such as smartphone, MP3 player, etc.) and play the audio source through the speakers. The volume 

is controlled via the externally connected device. It is not possible to regulate the volume via the cockpit.

USB Connection

It is possible to connect a USB stick to play audio or video files (USB stick not included in delivery).

Switching on the Treadmill.

Connect the mains plug of the power cable to a grounded 16A individually fused socket which has been installed by a professional 

electrician. Now switch the treadmill using the On/Off switch (located on the back of the motor housing).

Turning off the Treadmill

To turn the Treadmill off, press the power switch again. Then remove the remove the plug from the power socket.

CAUTION:

Before you turn off the treadmill, always make sure the incline is at zero level.