Step 3: Mounting the handlebar shaft
Slide the handlebar stem cover (52) onto the handlebar shaft(2) from below. Make sure that the covers are correctly
aligned.
Insert the M12x70 set screws (15) into the seat of the base frame (1) for the handlebar shaft and tighten them slightly so
that they grip.
Connect the cable (77) that protrudes from the bottom of the handlebar shaft (2) with the cable (78) that protrudes from
the steering shaft receptacle of the base frame (1).
Now insert the handlebar shaft (2) into the receptacle of the base frame (1). Then tighten the set screws (15) already
inserted.
Attention:
When inserting and fastening the handlebar stem (2), make absolutely sure that you do not crush or damage the cables.
Step 4: Mounting the cockpit
Connect the cockpit cable (77) sticking out of the handlebar shaft (2) with the corresponding cable (83) sticking out of the
cockpit (45 ).
Now lead the two cables of the hand pulse measurement (84) of the cockpit from above through the opening on the
handlebar shaft (2) and out again at the rear through the large opening on the handlebar shaft (2) - see also circle cut-out.
Now fix the cockpit (45) to the handlebar shaft (2) with four pan-head screws M5x15 (26).
Attention:
When inserting and attaching the cockpit (45), make absolutely sure that you do not crush or damage the cables.
7
Assembly