transport rollers
12
Transport
In order to transport your training device simply and safely, the front stand is equipped with transport rollers. To
move the exerciser, stand in front of the handlebars and grab them with both hands. Pull the training device gently
towards you and lower the handlebars until the rear stand no longer has contact with the ground and the main
weight of the exerciser is resting on the transport rollers. Now you can simply pull the exercise machine along on
the transport rollers and into the desired position. When lifting, transporting and positioning the device always make
sure that you have a secure footing.
Location & Storage
This training device was designed for exclusive use in dry, well-ventilated indoor areas. The use or storage in damp
or wet areas, such as saunas, swimming pools, etc. and in outdoor areas, such as balconies, terraces, gardens,
garages, etc. is excluded.
These locations may give rise to electronic defects, corrosion and rust due to the high humidity and low temper-
atures prevailing there. Under no circumstances will any claims for damages of this kind be accepted under the
warranty.
Please choose a dry, level and warm place to store your training device. For your own sake, also make sure that
you choose a training area which is sufficiently ventilated to ensure optimum oxygenation during training.
Before putting your training device back into operation after a long period of non-use, make sure that all fastenings
are secure.
Maintenance & Care
WARNING
Before starting cleaning, maintenance and / or repair work, the exerciser must be completely disconnected
from the power supply. This will only be the case if the power cable is disconnected from the power outlet
and the exerciser. Therefore, first disconnect the power plug from the power outlet, and then disconnect
the power cable from the exerciser. The mains cable may only be reconnected to the training device and
the power supply when all work has been completed and the proper training condition of the device has
been restored.
Cleaning
Clean your exerciser after each workout. Use a damp cloth and soap.
Never use solvents.
Regular cleaning contributes significantly to the preservation and longevity of your training device.
Damage caused by sweat or other liquids is not covered by the warranty under any circumstances. During training,
make sure that no fluid can enter the exercise machine or the computer.
Maintenance
Sealed bearings are used in your training device, lubrication of the bearings is not required.
Checking the fastenings
Check tightness of nuts and bolts at least once a month and re-tighten them if necessary
Checking the components
Before each workout, check that the saddle, seat support, handlebars and pedals are securely fastened.
WARNING:
Never train if one or more of these components are loose.
