Maxxus SpeedBike SX3, Installation & Operating Manual

18

Service Menu

Step 1: Selecting a Service Menu

Switch on the cockpit. Now press the START, MODE & RESET keys simultaneously for approx. 3 seconds. “EM” 

will appear in the display. Now press the MODE key.

Selecting the Different Menu Points

Select the different menu points by pressing the 

 keys.

Key Test (KEY TEST)

With this you can test the functionality of the individual keys.

Step 1:  

Press the MODE key

Step 2: 

“PRESS ALL KEYS” will appear in the display. Press each key from the left top to the right bottom  

key. Each time a key is pressed, a short signal sounds and the number of the respective key will  

appear in the display. When all keys have been pressed, “OK” appears in the display.

Display Test (DISPLAY TEST)

With this you can test the functionality of the LCD display.

Step 1: 

Press the MODE key. All LCD’s in the display will light up for a short time. 

Functions (FUNCTIONS)

Press the MODE key to get to the sub-menu.

Then press the 

 keys to select the different sub-menu items.

Switching the Standby Mode ON/OFF

When standby mode is activated, the cockpit automatically switches to standby mode after 5 minutes  

of inactivity. If you want to deactivate or activate the standby mode, proceed as follows:

Step 1:  

Press the MODE key. The display shows the current setting. Here, “OFF” stands for deactivated and  

“ON” for activated.

Step 2:  

Press the 

 buttons to select the desired setting.

Step 3:  

Press the MODE button to confirm.

Resetting the total values (ODO)

When you switch on the cockpit, the total training time and total training distance completed so far will be dis-

played. If you want to reset these values to zero, proceed as follows in this menu:

Step 1: 

Press the MODE key two times in succession.

Changing the display from kilometres to miles (UNITS)

Here you can change the display of the training distance and speed from kilometres and kilometres/h to miles 

and miles/h.

Step 1: 

Press the MODE key. The display shows the current setting.

Here “KM” stands for kilometres and “MILE” for miles.

Step 2:  

Press the 

 keys to select between the two values.

Step 3:  

Press the MODE key to confirm.

To exit the submenu, press the RESET key.

Locking function (SECURITY)

To protect the training device from being used by unauthorised persons, e.g. children, with the exception of the 

START/STOP and MODE keys you can deactivate the keypad here.

Step 1:  

Press the MODE key. The current setting appears in the display. Here “ON” means the locking  

function is active and “OFF” means the locking function is inactive.

Step 2:  

Press the 

 keys to select between the two settings.

Step 3:  

Press the MODE key to confirm.

If you have activated the lock function, the following appears in the display after you have switched on the cock-

pit. “CONSOLE LOCKED”. To unlock the display, press and hold the START/STOP and MODE keys simultane

-

ously for approx. 3 seconds.

Display of the Software Version (FACTORY SET)

The version of the cockpit software is displayed here.

Step 1:  

Press the MODE key. The software version will appear in the display.

Step 2:  

Press the MODE key again to return to the menu.

Cockpit